The first step to applying the vinyl overlay to your Honda Accord tail light is to heat the film so that it relaxes the edge. Make sure your fingers aren't touching the light's face; they should be tucked around the edge. Next, apply the film to the tail light, smoothing it across the body gap. If needed, use a squeegee to push out air. Carefully align the film, and make sure it isn't stretching or warping.
To apply the film to the tail light, you must first clean the light. Once you've cleaned the light, apply the clear coat. Then, use a 2,000-grit sandpaper to sand the surface of the light. Be sure to sand between coats so the film adheres properly. You can repeat this process as many times as needed until the tint has reached the desired appearance.
To apply the film to the tail light, lift off the backing paper, and plan over the light. Once you've done this, heat it up to stretch it over the light. Make sure the film reaches as much glass as possible. Remember to get the correct initial stretch, as this will determine how much the film will shrink. Once the film is properly applied, it should be very hard to notice any wrinkles in it.
dkcarlamp.com